Usually, the assembly of a ConSet table does not cause any major problems, if you follow the assembly instruction manual, which you can find on our download page.
But naturally it is possible that something could go wrong in the process. If this happens please proceed systematically like this: - Disassemble your table.
- Check that all parts are there by identifying every single part on the assembly instruction.
- Start the assembly all over by systematically following the assembly instruction - point by point.
If something still goes wrong, please call product support with your instruction manual in front of you. We will then walk you through the set-up process step-by-step.
We regularly edit our assembly instructions based on customer feed-back.
|  
|
|